Reliable VERVE 100SR Manual De Instrucciones página 15

GENERAL INFORMATION ON DESCALING
GRANULATE
The descaling granulate in the lime descaling cartridge must always remain slightly damp.
Where there are long intervals between ironing (with the water tank empty) the decaling
granulate must be moistened with water or kept apart from the Rotary Press in a sealed
plastic bag.
The water tank must be emptied during very long intervals between ironing.
New, full descaling cartridges are available by visiting the Reliable website at:
www.reliablecorporation.com.
CHECKING DESCALING CARTRIDGE
PLACEMENT FOR INITIAL MACHINE USE
The Reliable Rotary Press is supplied with a lime descaling cartridge inserted in the water
tank. The cartridge is placed below the cap of the filler.
1. Switch off the power and unplug the Rotary Press before removing/replacing the
cartridge. Remove the cap by pulling it upwards and make sure that the descaling
cartridge is pushed down fully. Press the cap onto the filler opening.
2. There is one spare cartridge supplied in a plastic bag with your Rotary Press. You
should keep the spare cartridge in the plastic bag until necessary to replace it in the
Rotary Press, to prevent the granulate in the descaling cartridge from drying out.
If the Descaling Granulate Used display LED is triggered approximately one minute after
inserting a lime descaling cartridge, proceed as follows:
Switch off the power and unplug.
Open the cap and push the lime descaling cartridge down fully into position. Replace the
cap.
Plug in the Rotary Press again and switch on the power.
2
12