Ironing Without Steam - Reliable VERVE 100SR Manual De Instrucciones

IRONING SETTINGS

IRONING WITHOUT STEAM

Immediately after the Power Switch is switched on, the green LED Power On illuminates. The
LED of the preselected Heat Setting flashes red. Select the required temperature setting for
ironing and wait until the corresponding red LED illuminates steadily. The heating shoe tem-
perature is automatically reheated during ironing. If a new temperature setting is selected
(including a lower setting), the corresponding LED flashes until the selected heating shoe
temperature is reached. (Illustration 1 – heat setting of Wool without steam)
If the current temperature setting is selected again, the heater is switched off and the red
LED goes out. The heater is now switched off but your Rotary Press remains ready for use.
(Illustration 2 – heating shoe will be cooling off but the roller will still move)
If the temperature is set to Synthetic or Silk, it is not possible to iron with steam.
(Illustration 3)
Note: When ironing without steam, the garment should be still slightly damp or dampened,
i.e., sprayed with water, to achieve the best results.
IRONING WITH DEMAND STEAM
The Rotary Press steams only when the foot pedal is in position B or C. It is now possible
to select between 3 steam settings: Minimum, Medium, and Maximum. This means that
less energy and water are used when not needed. Immediately after the Power Switch is
switched on, the green LED Power On illuminates. Select the required temperature setting
Wool, Cotton or Linen for ironing and wait until the corresponding red LED illuminates
steadily. The heating shoe temperature is automatically maintained during ironing. If a new
temperature setting is selected (including a lower setting), the corresponding LED flashes
until the selected heating the temperature is reached. (Illustration 4 – heat setting of Cotton
without steam)
If the current temperature setting is selected again, the heater is switched off and the red
and blue LED goes out. The heater is now switched off but your Rotary Press remains ready
for used. (Illustration 2 – heating shoe will be cooling off but the roller will still move)
When the Demand Steam Button is pressed, the blue LED illuminates. At the same time, the
blue steam setting button (in the medium position) flashes until the steam generator has
heated up. The LED then remains illuminated and steam generation begins. Select one of
the three steam settings. (Illustration 5)
14