How To Connect The Antennae; Where To Place The Receiver; Connections - Beyerdynamic Opus 600 Manual Del Usuario

48
2.2

How to connect the antennae

Connect the antennae to the TNC sockets
Please note that for diversity operation both antennae have to be connected. A weighting circuit silently
switches the signal with the better S/N ratio to the output.
Important:
Avoid obstacles between antennae and transmitter; otherwise the reception could be disturbed.
2.3

Where to place the receiver

• Place the diversity receiver in the same room or area as the transmitters. Make sure the diversity
receiver is placed as close as possible to the transmitter.
• Ensure that the NE 600 is installed as close as possible to the mixing console or amplifier so that the
display can be seen at all times.
• Do not place the diversity receiver near digitally controlled equipment.
2.4

Connections

• Connect the Audio output to the corresponding input of the mixing console or amplifier. Use the
balanced Audio output µ, when you connect the receiver to a mixer/amplifier with a balanced
input.
Use the unbalanced Audio output ¹, when you connect the receiver to the "LINE" input of an
•
instrument amplifier.
Make sure the Mic/Line level switch ¸ is switched to the correct position.
•
Switch to "LINE", when you connect the receiver to a mixer/amplifier. When connecting to a
guitar amplifier you should choose "LINE", or the volume may be too low.
Switch to "MIC-IN", when you connect the receiver to a microphone input.
Incorrect positioning of the Mic/Line level switch ¸ can cause distortion.
• Make sure the mains voltage shown on the power supply unit corresponds to the local mains
voltage.
• Connect the power supply unit
and to AC mains power.
NE 600 S
NE 600 D
µ
and
to the receiver or the power cable to the power connection
µ ¸ ¹
¹ ¸
Opus 600 – NE 600 Diversity Receiver
and set them at an angle (60°).
µ