Installing The Product; Security; Rf Safety; Antenna Precautions - Grundfos CIM 260 Instrucciones De Instalación Y Funcionamiento

2. Installing the product

WARNING
Electric shock
Death or serious personal injury
- Before starting any work on the product,
make sure that the power supply has
been switched off and that it cannot be
accidentally switched on.
- SELV wires must not come into contact
with other wires with higher voltages.
QR code for the CIU quick guide
Fig. 1

2.1 Security

Grundfos connected products must be behind a
firewall or connected to a private network.
If a firewall or private network is not in place, the
Grundfos product may be subject to a cyber-security
risk and becomes vulnerable to an attack or
compromise.
Follow the highly recommended configuration
requirements below. If in doubt, consult an IT
Infrastructure Specialist.
2.1.1 CIM 260, cellular
The CIM 260 modules are cellular-based modules
and require cellular connectivity through a private
Access Point Name (APN) to be securely connected
to the Internet. Any basic cellular connectivity
solution is not recommended, only private APNs are
recommended.
The private APN must be purchased from your
mobile network operator. The mobile network
operator will guide you through the setup process.
Private mobile
network
Private APN
Grundfos
device
Secure connectivity for CIM 260
Fig. 2
4
Internet
Firewall

2.2 RF safety

Installers and end users must be provided
with these installation and operating
instructions and operating conditions for
satisfying RF exposure compliance.
The antenna used for the product in which the CIM
260 or CIM 280 is fitted must be installed to provide
a separation distance of at least 20 cm from persons
and must not be co-located or operated in
conjunction with any other antenna or transmitter.
Interference of other electronic equipment may occur
if the equipment is inadequately protected.

2.3 Antenna precautions

The combined gain of the cable-antenna solution
used for this product must not exceed 2.0 dBi (800,
900, 1800, 2100, 2600 MHz).
2.4 Radio frequency radiation exposure
information
FCC ID: OG3-CIM2X0-3G-4G
IC: 10447A-CIM2X034G
Model: CIM 260-US or CIM 280-US
The enclosed FCC label must be placed
visibly on the product in which the CIM
module is installed.
The host product needs to be labelled
with:
Contains FCC ID: OG3-CIM2X0-3G-4G
Contains IC: 10447A-CIM2X034G.
This equipment complies with FCC and ISED
radiation exposure limits set forth for an uncontrolled
environment. This equipment must be installed and
operated with a minimum distance of 20 cm between
the radiator and your body.
This transmitter must not be co-located or operated
in conjunction with any other antenna or transmitter.