Program Selection; Error Codes; Nlx Nano Motor - NSK Multi Pad Manual Del Usuario

Program selection

1) Press SELECT key until program number displayed blinks at the normal display.
2) Press / key to select the program number that you want to use.
3) Press ENTER/SAVE key for 3 seconds or longer. The selection is completed.
NOTICE When the program you selected is modified, the color of "PRG" will inverse.

ERROR CODES

8
8–1 NLX nano MOTOR
The system incorporates an automatic diagnosis feature that can help to diagnose the cause of the problem
Details of each error code are listed below.
Error
Error Message
code
Over current (Hard)
E–00
Over current (Soft1)
E–01
Over current (Soft2)
E–02
Fault error
E–03
Over heat
E–04
Input over voltage
E–05
E–06 Lamp over voltage
Residual voltage
E–07
E–08 Over load
Motor start failure
E–09
Lamp under voltage
E–10
Esc error
E–13
EEPROM error
E–14
Cause
Excessive torque is loaded.
Abnormal electric current applied to
motor and circuit.
Excessive current is applied for a given
time.
Overcurrent in the motor driver.
Motor is overused.
Over voltage.
Lamp circuit over voltage.
Output circuit error.
The load continued to exceed the
limiter during the fixed time.
Handpiece/motor cord disconnection.
Electric circuit may fail.
Lamp circuit under voltage.
Over motor control range.
Memory read/write data error.
10
Solution
Remove the load from motor.
Release the foot control.
Release the foot control.
Contact your Authorized NSK Dealer.
Leave the motor is until it cools down.
Contact your Authorized NSK Dealer.
Contact your Authorized NSK Dealer.
Contact your Authorized NSK Dealer.
R e m o v e t h e l o a d f r o m m o t o r /
handpiece, and release foot control.
Check the handpiece cord is connected
with the handpiece properly.
Contact your Authorized NSK Dealer.
Contact your Authorized NSK Dealer.
R e m o v e t h e l o a d f r o m m o t o r /
handpiece, and release the foot control.
Contact your Authorized NSK Dealer.