Routine Control And Maintenance Operations And Safety Checks; Safety Information; Scrapping The Machine - RCM R850N Manual De Uso Y Mantenimiento

ROUTINE CONTROL AND MAINTENANCE OPERATIONS AND SAFETY CHECKS

The machine must be inspected by a specialist technician who checks its safety or for any damage or defects in the following cases:
• Before it is put into operation.
• After modifi cations or repairs.
• At regular intervals, as indicated in the «Routine maintenance and checks" table.
Every six months check that the safety devices are in good working conditions; the inspection must be made by authorized specialist staff .
To ensure that the safety devices are properly operating , the machine must be overhauled by specialist staff or skilled workshop every 5 years.
The person in responsable of the machine must make an annual check of its condition. During this checking, he must decide whether the machine
still complies with the technical safety regulations. After checking it has to apply on the machine a label of checking made.
Periodic maintenance and checks table
1
2
3 check that the main brush is not entangled with string,wire,...
4
5
6
7
8
9
10
11
12
13
14
E
B
Cleaning
When cleaning and washing the machine, take care when using aggressive detergents, acids, etc.
Follow the instructions provided by the detergent producer, and wear protective clothing if appropriate (e.g. overalls, gloves, goggles, etc. - see EEC directives on
this subject).
Explosive atmosphere
The machine is not constructed to work in environments where there is a risk that there might be explosive gases, dusts or vapours, and so its use in an explosive
atmosphere is FORBIDDEN.
Disposal of harmful substances
Comply with the laws in force on waste disposal and treatment when disposing of the material collected, the machine fi lters and spend material such as batteries,
motor oil, etc.
The machine should be consigned to an authorised disposal organisation, which will manage disposal correctly, especially with regard to the oil and
fl uids, fi lters, and batteries. ABS and metal parts should be recycled as secondary raw materials. Rubber hoses and gaskets, and ordinary plastic and fi breglass, must
be separated and consigned to municipal waste companies.
The packing of the machine is manufactured by recycling materials. Consign the spent materials to operators authorized to dispose.
check the battery electrolyte level
check coal brushes of drive and brush motor
check the dust fi lter
replace the dust fi lter
check traces of side and main brush
check belt tension
check the engine oil level
check the engine pre-fi lter and air fi lter
clean the engine air fi lter / replace the pre-fi lter
replace the engine air fi lter
replace the engine oil
replace fuel fi lter
replace the hydraulic oil
Electric version
Petrol version
!

SAFETY INFORMATION

SCRAPPING THE MACHINE

53
every hours...
8 40 100 150 500
E B
E
E+B
E+B
E+B
E+B
B
B
B
B
B
B
1500
E+B
B