14. WINDING A BOBBIN / BEWICKELN EINER SPULE / BOBINAGE D'UNE CANETTE /
MODO DE BOBINAR UNA BOBINA / AVVOLGIMENTO DELLA BOBINA /
底线的绕线方法
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the follow-
ing work after turning the power off and ascertaining that the motor is at rest.
WARNUNG :
Um durch plötzliches Anlaufen der Nähmaschine verursachte Verletzungen zu vermeiden, führen Sie die
folgende Arbeit erst aus, nachdem Sie den Netzschalter ausgeschaltet und sich vergewissert haben, daß
der Motor vollkommen stillsteht.
AVERTISSEMENT :
Pour ne pas risquer des blessures causées par une brusque mise en marche de la machine, toujours la
mettre hors tension et s'assurer que le moteur est au repos avant d'effectuer les opérations suivantes.
¡AVISO!
Para protegerse contra posibles lesiones personales debido a un arranque brusco de la máquina de co-
ser, cerciórese de comenzar el siguiente trabajo después de desconectar la corriente y de estar seguro
que el motor está completamente parado.
AVVERTIMENTO :
Per evitare possibili ferimenti causati dall'avvio improvviso della macchina per cucire, prima di effettuare
le seguenti operazioni spegnere l'interruttore dell'alimentazione ed assicurarsi che il motore abbia com-
pletamente cessato di ruotare.
警告 :
为了防止突然起动造成人身事故,请关掉电源,确认马达确实停止转动后再进行操作。
F
G
4
3
I
1) Pass the thread in the order, A through I . Then wind it several turns round the bobbin.
(It is not necessary to thread B and C in the case where control panel 5 is not mounted.)
2) Tilt bobbin presser 1 .
3) Adjust bobbin thread amount adjustment screw 2 to wind a bobbin about 80% of its capacity.
Turn the screw counterclockwise to increase the amount of thread to be wound round the bobbin, or clockwise to
decrease it.
4) If the bobbin is wound unevenly, correct it by moving thread guide 3 of the bobbin winder back or forth.
Then tighten screws 4 .
5) When the bobbin is fi lled up, the bobbin presser automatically releases the bobbin and the bobbin winder stops running.
26
C
D
E
H
1
5
B
2
A