Electrical System Maintenance; Removing The Battery - SHERCO SE 250i Manual De Propietario

SE 250i / 300i
brakes (continued)
2

electrical system maintenance

reMOving THe baTTery

2
114
1
1
3
Install the new pads.
Reinstall the retaining pins
Check the brake fluid level and fill if necessary.
( p.110 et p. 111)
☛
aTTenTiOn
Do not use the bike until the brake lever and the pedal
are operational. «Pump» the brake lever / brake pedal
up and down until the brake pads are in contact with
the discs.
Turn off all electric devices and stop the engine.
aTTenTiOn
- SE 250/300 i (standard): Confirm that the key start
is in the OFF position.
- SE iR 250/300 (racing): Confirm that the on / off
switch is in the OFF position.
If this is not done there is a significant risk of
damage to the computer (ECU).
- Remove the seat (
☛
- Remove the air filter (
- The battery is located at the bottom of the filter
housing.
- Remove the two screws
battery retaining bracket.
- Disconnect the negative cable from the battery
- Disconnect the battery positive cable
- Remove the battery from the top.
and clips
2 1
p.96)
p.96).
☛
that retain the
1
.
3
.
2