Time Setting - SHERCO SE 250i Manual De Propietario

n Engine rPM Function
Fig 8 RPM Function
n Time setting
Fig 9 Setting the time
nOTe
- If the the speed unit is km / h,Time will be
in the format 0-24
- If the speed unit is in mph, Time will be in
the be 0-12 format (AM-PM).
n adjusting the unit of measurement (km or miles)
Fig 10 Adjusting the unit of measurement
Displays real-time engine speed in rev / min
If the vehicle speed = 0km / h (or mph)
Pressing the Function Button STDBY for at least
5 seconds displays the time and allows the time
to be changed. (see fig.9)
It is possible to change the hour then the
minutes. The information will blink active.
a short press of the button : changes the
active unit hour or minute.
a long press of the button: :
- Changes the setting of the hour and or minute.
- Exits the SETUP menu.
It is possible to display the speed as km / h (or mph)
To change units hold the TOTAL Function - Button
down for at least 5 seconds. It is possible to
change settings when only the two logos km / h
and mph are displayed (see fig.10). When active
the logos will blink.
a short press of the button : changes the unit
of measurement.
a long press of the button : selects the unit of
measurement and returns to the main menu.
79