Remote Control - Sulion BOMBAY IOT Instrucciones De Montaje

Remote control

MED
Light
HI
LOW
ON/OFF
STOP
2H
1H 4H
8H
Syncing the receiver and the remote control for fan operation
If the receiver and transmitter of this fan are properly synchronized, the fan will work. During synchronization the receiver
recognizes the signal from the transmitter, this is called the learning process.
Make sure the fan is disconnected. This is essential for the synchronization process.
Unless the synchronization process has been successful, the fan will work partially or will not work. By default, all fans have
been preconfigured at the factory and should be functional once the installation is completed and the fan is turned on.
If the remote control does not work after installation or during use, synchronization can be performed as indicated below. Note
in any case that there could be other reasons why your fan or remote control does not work:
Make sure all connections are correctly made.
Make sure that the remote control contains batteries.
Make sure that all switches (main and isolation) are on.
Instructions for synchronizing the receiver and the remote control
This fan is pre-paired. In case of losing synchronization, there are two modes of synchronization: Universal Mode and Unit
Mode:
Universal Mode:
• This type of synchronization allows you to control one or more nearby fans with the same remote control.
• Synchronization:
1.-Connect the power (wall switch) of the fan or fans, and just then, within the next 3 seconds, press LOW + MED at
sametime.
2.-A sound of type "beep" indicates that the connection has been executed and the equipment can work normally.
3.-Now, the transmitter and receiver of the fan/s will have been synchronized. Remove the current of the fan/s by means of
the switch or the breaker and after 10 seconds turn it/them on, this step is the one that closes the synchronization process
Unit Mode:
• This type of synchronization allows you to control two or more nearby fans independently, each with its remote control.
• Synchronization:
1.-Connect the power (wall switch) of a single fan, and just then, within the next 3 seconds, press LOW + MED at same
time.
2.-A sound of type "beep" indicates that the connection has been executed and the equipment can work normally.
3.-Now, transmitter and receiver of the fan/s will have been synchronized. Remove the power of the fan using the switch
or the breaker and after 10 seconds turn it on again, this step is the one that closes the synchronization process.
4.-To synchronize another fan and remote control, you must disconnect the power or turn off the wall switch (if not shared
with the new fan to be synchronized) of the fan already synchronized and connect only the fan you want sync up. Then
repeat the points from 1 to 3
FAN
Turn on / Turn off fan
ON/OFF
Turn on / Turn off light
LIGHT
Change color temperature
ON/OFF
Turn off fan
STOP
High speed (Speed 3)
HI
Medium speed (Speed 2)
MED
Low speed (Speed 1)
LOW
Timer 1h
1H
Timer 2h
2H
Timer 4h
4H
8H
11