Cleaning The Lift; Assembly And Commissioning; Set Up Guidelines; Set Up And Anchoring The Lift - Nussbaum POWER LIFT HDL 6500 SST DG Instrucciones De Servicio

Rust is brought out by mechanical damage,
wear, aggressive deposits (de-icing salt, leaking
operating fluids) cleaning that is not done or in-
complete.
The affected areas can be treated by using a
sanding cloth (A 280 grit). If required, post-treat
the areas with a resistant material (paint etc.).
• Testing the safety devices.
• According to a statement by the axis controller
manufacturer, the battery on the axis controller
has a lifetime of approx. 4 ½ - 5 years under nor-
mal operating conditions. To prevent permanent
loss of data due to an empty battery, the axis
controller must be sent to the main factory after
approx. 4 years. Please contact your dealer.
• Check the electrical lines and their cable con-
duits for damage.
• Retighten all fastening screws using a torque
screw.
(see the table in the detailed operating manual)
Figure 10
7.2

Cleaning the lift

A regular and expert clean helps retain the value
of the lift.
Additionally, it can also be a pre-requisite for the
preservation of guarantee claims for any eventual
corrosion damage.
The best protection for the lift is regular removal of
contaminants of any kind.
This includes above all:
OPI-POWER LIFT HDL 6500 SST DG-7000 SST DG-8000 SST DG - HYMAX H 6500 DG-H 7000-V1.0-DE-EN-FR-ES-IT
• De-icing salt
• Sand, pebbles, earth
• Industrial dust of all types
• Water, also in connection with other environmen-
tal influences
• Aggressive deposits of all types
• Permanent humidity due to insufficient ventilation
The frequency of lift cleaning depends, among oth-
er things on the frequency of use, of lift handling,
of workshop cleanliness, and the location of the
lift. Furthermore, the degree of contamination de-
pends on the time of year, the weather conditions
and workshop ventilation. Under adverse circum-
stances, weekly lift cleaning might be required,
however a monthly cleaning may be sufficient.
Do not use and aggressive and abrasive materials
for cleaning, rather use mild cleaners, e.g. a com-
mercially available detergent and lukewarm water.
• For cleaning, do not use high pressure washers
(e.g. steam cleaners).
• Carefully remove all contamination with a
sponge, or if required with a brush.
• Make sure that there is no residue of the cleaner
on the lift.
• Rub the lift dry with a cloth after cleaning.
8

Assembly and commissioning

8.1 Set up guidelines
• Lift set up is done by trained manufacturer per-
sonnel or a contract partner. If the operating
company has appropriately trained assemblers,
the lift can also be set up by them. Set up is to be
done according to the assembly instructions.
• A standard lift may not be set up in explosion en-
dangered spaces or wash halls. (It is necessary to
consult with your dealer).
• Before setting up, verify that there is a sufficient
foundation or make it according to the guidelines
in the foundation plan. The set up location must
be level and even. Foundations in open air and
spaces where winter storms or frost are to be ex-
pected, must have a foundation to frost depth.
• An on-site electrical connection of 3 ~/N + PE,
400V, 50Hz is to be provided. The supply is to be
secured on-site with 16 ampere fuses. The con-
nection point is located on the operating boxes.
• To protect the electrical cable all cable conduits
are to be fitted with cable sleeves or flexible plas-
tic pipes.
8.1.1 Set up and anchoring the lift
i Before setting up the lift, ensure that everything
possible is done to prevent accidents due to
113