Publicidad
English
To replace shield/peak, place the black spring clip on the base plate on
each side as illustrated (pay attention to the proper direction).
Place the shield on the helmet in the fully closed position, as illustrated,
and place the peak so that the two screw holes line up ensuring the
two pins of the base plate are in the lower screw hole of the peak, as
illustrated.
LEFT
RIGHT
Place the pressure plate on the peak (note that the L & R embossed on the
plate indicate Left and Right on the helmet when the helmet is worn) and
install the two screws through each pressure plate into the helmet and
tighten with flat blade screwdriver or coin. Do not over-tighten. Work the
shield up and down to check the operation.
To use the helmet with just the peak, place the black spring clip on each
side as per previous instructions. Place the peak, pressure plates and
screws, then tighten screws as per previous instructions.
LEFT
RIGHT
To use the helmet with just the shield, place the black spring clips and
shield as per previous instructions. Then, place the shield pressure plates,
included in package, on the shield (note that the L & R embossed on the
plate indicate Left and Right on the helmet when the helmet is worn),
install the screws through each shield pressure plate into the helmet and
tighten with flat blade screwdriver or coin. Do not over-tighten. Work the
10
shield up and down to check the operation.
Publicidad
Capítulos
