Raising And Lowering The Presser Foot; Changing The Presser Foot; Removing And Attaching The Foot Holder - Janome MyStyle 100 Manual De Instrucciones

e
w
q
e
w
q
e
e
w
q
w
r

Raising and Lowering the Presser Foot

The presser foot lifter raises and lowers the
presser foot.
You can raise the foot about 1/4" (0.6 cm) higher
than the normal up position for easy removal of
the presser foot, or to help you place heavy fabric
under the foot.
q
q Lowered position
w
w Normal up position
e
e Extra up position

Changing the Presser Foot

To remove:
Raise the needle to its highest position by turning
the handwheel counterclockwise. Raise the
presser foot, and press the lever on the back of
the foot holder.
q
q Lever
CAUTION:
Turn OFF the power switch before changing the
foot. Always use the proper foot for the selected
pattern. The wrong foot can cause the needle to
break. Do not push the lever down to prevent it
from being broken.
To attach:
Place the desired presser foot, so that the pin
on the foot lies just under the groove on the foot
holder. Lower the presser foot lifter to lock the foot
in place.
w
w Groove
e
e Pin

Removing and Attaching the Foot Holder

WARNING:
Turn OFF the power switch before detaching or
attaching the foot holder.
To remove:
Remove the setscrew by turning it
counterclockwise with a screwdriver and remove
the foot holder.
To attach:
Match the hole in the foot holder with the threaded
hole in the presser bar. Fit the setscrew into the
hole. Tighten the screw by turning it clockwise with
a screwdriver.
q
q Setscrew
w
w Foot holder
e
e Hole
r
r Threaded hole
12