Winding The Bobbin; Additional Spool Pin - Janome MyStyle 100 Manual De Instrucciones

q
z
w
x
e
c
v
b
q

Winding the bobbin

z Hold the thread with both hands and
z
pass the thread under the thread guide.
q Thread guide
q
x Guide the thread around the bobbin
x
winding thread guide.
w Bobbin winding thread guide
w
c Pass the thread through the hole in the
c
bobbin from the inside to the outside.
Put the bobbin on the bobbin winder
spindle.
e Bobbin winder spindle
e
v Push the bobbin winder spindle to the v
right.
b Hold the free end of the thread in your b
hand and start the machine.
Stop the machine when the bobbin has been
wound a few layers, and cut the thread close
to the bobbin.
n Start the machine again. When the bobbin n
is fully wound, it will stop automatically.
Stop the machine and return the bobbin
winder spindle to its original position by
moving it to the left, and cut the thread with a
pair of scissors. Remove the bobbin from the
bobbin winder spindle.
NOTE:
The machine will not sew until the spindle has
been returned to the left.

Additional spool pin

The additional spool pin is for bobbin winding
without unthreading the machine.
q Additional spool pin
q
18