Assembly Preparation / Electrical Connection; Connected Loads - GUTMANN VIENTO Instrucciones De Montaje

EN

Assembly preparation / Electrical connection

WARNING AGAINST ELECTRICAL TENSION !
THERE IS DANGER TO LIFE !
There are energised parts near this symbol. Covers marked with this symbol may
only be removed by an authorised electrician.
• The electrical connection may only be carried out by an authorised specialist!
• The statutory regulations and connection conditions of the local electrical supply com-
pany must be observed in full.
• When the device is connected, a device must be provided which makes it possible to dis-
connect the device from the mains with an opening width of at least 3 mm all poles using
a contact. LS switches, fuses and contactors are regarded as suitable disconnecting de-
vices. When connecting and repairing the device, disconnect it from the power supply u-
sing one of these devices.
• The protective conductor must be long enough so that if the strain relief fails, it will only
be subjected to tensile stress after the current-carrying cores of the connecting cable.
• The excess cable length must be pulled out of the installation area below the device.
• Please make sure that the mains voltage is the same as on the nameplate.
Complete protection against accidental contact must be ensured by installation.
•
• Attention: Incorrect connection can lead to destruction of the power electronics.
• The device is only approved for permanent installation. It must not be connected with a
safety plug.

Connected loads

Cooker hob mains voltage:
1N~ 220-240V / 32A , 50/60Hz
2N~ 380-415V / 16A , 50/60Hz
Connecting cable available at the factory
• The hob is equipped with a temperature-resistant connection cable at the factory.
• Damaged lines may only be replaced by the manufacturer or his customer service.
24
Observe EN 60 335-2-6 / 2016-02 !