Waeco PerfectView CRT 100 Instrucciones De Montaje Y De Servicio página 50

Assembly of the outside camera RV-20 (RV-100)
If you are not quite sure about the assembly place selected by you, inquire with the
construction's manufacturer or its agency.
Hold the camera holder at the selected assembly place and mark at least 2 different
drilling points (see G 1, illustration 10).
When fastening with sheet-metal screws
The fastening with sheet metal screws may only be made on sheet steels with a
minimum thickness of 1.5 mm.
The following is to be considered when executing drill holes in the metal plate.
– Check before whether sufficient free space for the drill outlet is present.
– In order to prevent a running of the drill, prick punch with hammer and prick punch.
– Debur all drill holes and provide with rust protection.
Drill a hole of Ø 4 mm at the points drawn beforehand.
Stick the double-sided adhesive insulating plate onto the assembly side of the holder.
This pad serves as gasket and lacquer protection (see G 1, illustration 11).
Screw on camera holder with the metal screws 5 x 20 mm (see G 1, illustration 11).
Necessary parts for the attachment with sheet-metal screws (see G 1, illustration 1 to 4).
When attaching thread screws
The following is to be considered when executing drill holes:
– Check before whether sufficient free space for the drill outlet is present.
– In order to prevent a running of the drill, prick punch with hammer and prickpunch.
– Debur all drill holes and provide with rust protection.
– Pay attention that the nuts cannot pull themselves through the construction when
tightening (use possibly larger washers or sheet metal plates).
Drill a hole of Ø 5.5 mm at the points drawn beforehand.
Stick the double-sided adhesive insulating plate onto the assembly side of the holder.
This pad serves as gasket and lacquer protection (see G 1, illustration 12).
Screw on camera holder with the thread screws M 5 x 20 mm, or longer
thread screws depending upon construction strength.
Necessary parts for the attachment with thread screws (see G 1, illustration 6 to 9).
50