Operating Range; Burner Connection To The Boiler - baltur TBML80 PN Manual De Instrucciones

OPERATING RANGE

E
N
G
L
I
S
H
The working ranges are obtained from test boilers correspond-
ing to the standard EN267 and are indicative of the combination
burner-boiler. For correct working of the burner the size of the
combustion chamber must correspond to current regulations; if
not the manufacturers must be consulted.

BURNER CONNECTION TO THE BOILER

ASSEMBLING THE HEAD UNIT
A) Adjust the position of connector flange 5 by loosening the
screws 6 so that the combustion head penetrates the advised
amount into the combustion chamber as recommended by the
generator manufacturer.
B) Fit the rigid pipe in the housing provided on the connection
flange and fasten it with the screw. This pipe will be cut flush
with the diffuser (see 0002934670).
C) Position insulating seal 3 on the sleeve, placing cord 2 between
the flange and the seal.
D) Fasten the Combustion Head unit 4 to the boiler 1 by means
of the stud bolts, washers and the nuts provided 7.
Completely seal the space between the burner sleeve and
!
the hole in the refractory material inside the boiler door with
suitable material.
Thermal power of methane gas
Thermal power of diesel oil
6 / 28
0006081470_201105