Disp Mode - BRAND Transferpette electronic Instruccionesde Manejo

DISP Mode

Program for discharging an aspirated liquid in pre-defined steps.
The volume aspirated will be a little bit more than actually needed.
Speed adjustment is described on pages 38 and 39.
What to do
1.
Bring up the menu
2.
Select DISP
mode
3.
Confirm DISP
mode
4.
Prepare for
dispensing
5.
Set dispensing
step volume
6.
Confirm dispensing
step volume
50
How to do it
Press the MENU key three
times to bring ap the mode
selection menu.
'Mode' blinks.
Scroll through the modes
using the arrow keys until
'DISP' appears.
'Mode' continues to blink.
Press the ENTER key.
The Display now shows
'blo' for blow-out.
Press the pipetting key
once to move the piston
into the start position.
The arrow in the display
points upwards (aspiration).
Press the arrow keys (+/-)
to set the volume. Holding
the arrow key down
accellerates the rate of
change. 'VOL' blinks.
Press the ENTER key.
The display now shows the
new volume setting for the
dispensing steps and the
max. number of steps.
'Steps' blinks.
The Programs · Settings and Use
Keys to press Display readout
3x
1x
1x
+
–
1x