Tabla de contenido
Publicidad
SET
POWER
The menu allows the generator power to be set Minimum power 1, maximum power 5.
To set: OK > SET > POWER.
ROOM TEMPERATURE
The menu allows to set the room temperature to reach. (front ventilation must be active). Range:
OFF 07 40°C.
To set: OK > SET > ROOM TEMP..
H2O TEMPERATURE
The menu allows the boiler temperature to be set Range: 65 - 80°C.
To set: OK > SET > TEMP.. H2O.
VENTILATION
This menu allows to enable or disable the operation of the motor and to adjust the fan speed.
To set: OK > SET > VENTILATION.
EASY SETUP
The volumetric weight of the pellet is the ratio between the weight and the volume of the pellet.
This ratio may change while keeping the quality of the pellet unchanged. By using the EASY SETUP
function, it is possible to change the calibration of the volumetric weight by increasing or decreasing
the pre-set values.
In the stove program, the available values go from "– 3" to "+ 3"; all stoves are calibrated during
production with the optimal value which is 0
If you notice an excessive deposit on the burning pot, access the EASY SETUP program and lower the value of one unit to "- 1"; then wait until
the next day and if there is no improvement, decrease again, to a maximum of "- 3". Instead, if it is required to increase the calibration of the
volumetric weight of the pellet, go from the factory value "0" to "+ 1, + 2, + 3" as required.
To set: OK > SET > EASY SETUP.
EXCESSIVE DEPOSIT OF PELLET IN THE BURNING POT
-3
-2
SECOND
THIRD DECREASE
DECREASE
RANGE IF THE
RANGE IF THE
FIRST TWO ARE
FIRST IS NOT
NOT ENOUGH
ENOUGH
N.B.: If these settings do not solve the deposits of pellets present in the burning pot, please contact the service centre of your area.
66
NORMAL OPERATION
-1
FIRST DECREASE
OPTIMAL FACTORY
RANGE (TEST FOR
VALUE
1 DAY)
ENGLISH
LITTLE DEPOSIT OF PELLET IN THE BURNING POT
0
+1
FIRST INCREASE
RANGE
+2
+3
SECOND
THIRD INCREASE
INCREASE RANGE
RANGE IF THE
IF THE FIRST IS
FIRST TWO ARE
NOT ENOUGH
NOT ENOUGH
Publicidad
Tabla de contenido
