Tabla de contenido
Publicidad
TO FIND OUT WHERE YOUR NEAREST SERVICE CENTRE IS, CONTACT YOUR DEALER OR GO TO THE WEBSITE:
CLEANING AND MAINTENANCE
FOLLOW THE INSTRUCTIONS ALWAYS IN COMPLETE SAFETY!
Š Make sure that the power supply cable plug is disconnected, since the generator could be programmed to switch-on.
Š That the generator is completely cold.
Š The ashes are cold.
Š Ensure e cient air exchange in the room during the product cleaning operations.
Š Poor cleaning will compromise correct operation and safety!
MAINTENANCE
For correct operation, the generator must undergo routine maintenance by a quali ed technician, at least once a year.
The periodic inspection and maintenance operations must always be performed by specialised, quali ed technicians, who operate in
accordance with the laws in force and the instructions given in this use and maintenance manual.
EVERY YEAR HAVE THE FUMES EXHAUST PLANT, FUME DUCTS AND "T" FITTINGS AND INSPECTION CAPS CLEANED
BENDS AND HORIZONTAL STRETCHES IF PRESENT!
THE CLEANING FREQUENCY OF THE GENERATOR IS INDICATIVE! IT DEPENDS ON THE QUALITY OF THE PELLETS
USED AND ON THE FREQUENCY OF USE.
SOMETIMES THESE OPERATIONS MUST BE PERFORMED MORE OFTEN.
PERIODIC CLEANING BY THE USER
As indicated in this use and maintenance manual, periodic cleaning must be performed paying great attention, after having read the
indications, to the procedures and times described herein.
CLEANING THE SURFACES AND COVERING
Never use abrasive or chemically aggressive detergents for cleaning!
The surfaces must be cleaned when the generator and covering are completely cold. For the maintenance of the surfaces and metal parts,
simply use a cloth dampened with water or water and neutral soap.
Failure to comply with these instruction may damage the surfaces of the generator and cause the invalidation of the warranty.
CLEANING THE CERAMIC GLASS
Never use abrasive or chemically aggressive cleaning agents for cleaning!
The ceramic glass must be cleaned when the glass is completely cold.
To clean the ceramic glass, simply use a dry brush and some damp newspaper dipped in ash. If the glass is very dirty, use a speci c cleaning
agent for ceramic glass. Spray a small amount on a cloth and use it on the ceramic glass. Do not spray the cleaning agent or any other liquid
directly on the glass or seals!
Failure to comply with these instruction may damage the surfaces of the ceramic glass and cause the invalidation of the warranty.
CLEANING THE PELLET TANK
When the tank is completely empty, disconnect the power cable of the generator and remove the residues rst (dust, chippings, etc.) from the
empty tank, and then ll it.
THE FOLLOWING IMAGES ARE FOR ILLUSTRATIVE PURPOSES.
SCRAPERS:
The heat exchangers are cleaned automatically (adjustable) via
a mechanical system that allows constant heat output over time.
70
WWW.LANORDICA-EXTRAFLAME.COM
ENGLISH
Publicidad
Tabla de contenido
