Allmand NIGHT-LITE NL5000 Manual Del Operario página 12

WARNING
Failure to lock the trailer tongue in the park position could
cause the trailer tongue to drop, resulting in death or seri-
ous injury. Always lock the trailer tongue in the park posi-
tion with the locking pin.
To lower the trailer tongue (towing position)
1. Remove the locking pin securing the trailer tongue in the
park position (E, Figure 4).
2. Lower the trailer tongue to the towing position (C, Figure
4). Secure with the locking pin (A). Be sure to secure
the locking pin with the attached hairpin.
WARNING
Failure to lock the trailer tongue in the towing position
could cause the front of the light tower trailer to collapse,
resulting in death or serious injury. Always lock the trailer
tongue in the towing position with the locking pin.
C
B
Figure 4
Connecting The Light Tower Trailer To The Tow
Vehicle
1. Place wheel chocks (not supplied) against the front and
back of each wheel on both sides of the light tower trailer.
2. Check to be sure the trailer tongue is lowered and locked
in the towing position. See Trailer Tongue.
3. Use the tongue jack to raise the trailer coupler above
the tow vehicle's hitch ball. See Operating The Tongue
Jack.
4. Position the tow vehicle's hitch ball under the trailer cou-
pler.
5. Lower the trailer coupler onto the hitch ball with the
tongue jack.
6. Lock the trailer coupler. See Using The Trailer Coupler.
12
D
A
E
7. Attach the safety chains (A, Figure 5) to the tow vehicle's
hitch frame. Cross the chains under the tongue as
shown. Leave enough slack in the chains to allow for
turns, but not so much that the chains will contact the
road surface.
8. Connect the trailer lighting connector (B, Figure 5) to
the tow vehicle lighting connector. Make sure the trailer
lighting harness has adequate length to prevent discon-
nection when turning, but not so much length that the
harness will contact the road surface. Once connected,
check the stop, turn signal, tail, side marker and license
plate lamps for proper operation.
9. Fully raise the tongue jack, then retract into the transport
position. See Operating The Tongue Jack.
10. Remove the wheel chocks from both sides of the light
tower trailer wheels.
Figure 5
Operating The Tongue Jack
The unit is equipped with a tongue jack to support the front of
the light tower trailer and to level the trailer front-to-rear.
To extend the tongue jack
1. Pull the lock lever (A, Figure 6), rotate the tongue jack
into the operating position (B), and release the lock lever.
Make sure the lock lever engages the locking hole and is
secure.
WARNING
Failure to lock the tongue jack in the operating position
could cause the front of the light tower trailer to collapse,
resulting in death or serious injury. Always be sure the lock
lever locks the tongue jack in the operating position.
B
A
www.allmand.com