Allmand NIGHT-LITE NL5000 Manual Del Operario página 19

Automatic Engine Shutdown System
The engine is equipped with an automatic engine shutdown
system to prevent engine damage in the event of a low oil or
overheat condition.
If the engine has automatically shut down, locate the source
of the failure and repair before restarting the engine.
E
B C
A
Figure 15
Light Tower Operation
Adjusting The Lights
WARNING
Burn Hazard
• Adjusting the lights while the lights are turned on could
result in death or serious injury. Always adjust the
lights with the lights turned off.
WARNING
Burn Hazard
• The light fixtures become extremely hot during use.
• Always use caution and heat–resistant glove when
handling the lights or allow the lights to sufficiency cool
down before handling.
Adjusting The Light Fixtures
NOTE: The light fixtures must be adjusted before raising the
light tower.
1. Turn the tower lights off, and wait 10 minutes for the lights
to cool. See Operating The Tower Lights.
2. Manually adjust each fixture (up/down/left/right) to suit
lighting needs. See Figure 16.
3. When lighting operations are complete, adjust the light
fixtures to the transport position, with the fixtures fac-
ing straight back toward the rear of the light tower trailer.
See Figure 16.
D
F
NOTE: When transporting on a trailer, position the two top
light fixtures straight down to provide additional overhead
clearance. See Transporting On A Trailer in the Preparing
The Light Tower Trailer For Use section.
Figure 16
Rotating The Light Tower
CAUTION
Rotating the light tower will cause the light fixtures to
swing, and could result in mild to moderate injury. Be
careful to rotate the tower slowly, and be aware of the light
fixtures while rotating the tower.
1. Turn the tower lights off, and wait 10 minutes for the lights
to cool. See Operating The Tower Lights.
2. Loosen the light tower locking knob (A, Figure 17).
3. Using the handles (B, Figure 17), rotate the light tower in
the desired direction.
4. Tighten the light tower locking knob.
WARNING
Failure to tighten the light tower locking knob may cause
the light fixtures to swing inadvertently, especially in windy
conditions or during transport, and could result in death
or serious injury. Always tighten the tower locking knob
securely after rotating the light tower.
5. When lighting operations are complete, rotate the light
tower to the transport position: Align the light tower lock-
ing knob with the front center of the light tower base (C,
Figure 17). Be sure to tighten the light tower locking
knob securely.
19
en