Maintenance, Storage And Transport; Environmental Protection; Machine Information; Description Of The Machine And Its - Stiga 85 Combi QF Manual De Uso

• Disengage the cutting device or
power take off and take the cutting
device to its highest position:
– During transfer from one
operating area to another.
– When crossing grass-free terrain.
• In the event of failures or accidents
when working with the machine, stop the
engine immediately and move the machine
away to avoid causing further damage; in the
event of accidents with injuries to operators
or third parties, take the first aid measures
which are most appropriate to deal with the
situation and contact a health care facility for
the necessary treatment. Carefully remove
any debris which could cause damage or
injury to persons or animals if ignored.
Limits of use
• Never use the machine if the safeguards are
damaged, missing or incorrectly installed.
• Do not attempt to defeat, deactivate,
remove or tamper with the installed
safety systems/microswitches.
2.4 MAINTENANCE, STORAGE
AND TRANSPORT
Regular maintenance and correct
storage is essential for machine safety
and optimum performance.
Never use the machine with worn or
damaged parts. Faulty or worn-out parts
must always be replaced and never repaired.
Only use original spare parts: The use or
non-original and/or incorrectly fitted parts
will compromise the safety of the machine,
may cause accidents or personal injuries
for which the Manufacturer is under no
circumstance liable or responsible.
Maintenance
• Be careful during adjustment of the
machine, to prevent entrapment of the
fingers between moving parts of the cutting
means and fixed parts of the machine.
Storage
• To reduce the risk of fire, never
leave containers holding waster
materials inside buildings.
Handling and transport
• If the machine is transported on a
truck or trailer, use ramps with suitable
resistance, width and length.
• When transporting the machine with
a vehicle it is necessary to:
– get an adequate number of people to load
the machine with the engine switched off;
– position the machine where it does not
constitute any kind of hazard to anyone;
– secure it firmly to the means of transport
using cables or chains to stop it from
turning over and getting damaged.

2.5 ENVIRONMENTAL PROTECTION

Safeguarding the environment must be a relevant
and priority aspect of machine use, of benefit to
the community and the environment we live in.
• Avoid being a disturbance to the
neighbourhood. Only use the machine at
reasonable times of day (i.e. avoid using it
very early in the morning or late in the evening
when it may cause a disturbance to others).
• Adhere strictly to the local regulations
governing the disposal of packaging, oil,
fuel, filters, damaged parts or any other
element which may have an impact on
the environment; this waste should not be
disposed of along with standard household
waste, but must be disposed of separately
and sent to special waste disposal
facilities for handling and recycling.
• When the machine is withdrawn from service,
do not dump it in the environment, but take
it to a waste disposal facility in accordance
with the local regulations in force.

3. MACHINE INFORMATION

3.1 DESCRIPTION OF THE MACHINE
AND ITS INTENDED USE
The machine described herein is an
interchangeable piece of equipment
known as a cutting means assembly.
It is an interchangeable gardening tool
designed to be connected to another machine
(a ride-on lawnmower with front cutting)
from which it receoves drive and support.

3.1.1 Foreseen use

The machine "cutting-means assembly" has been
specifically designed and built to mow grass.
In general this machine can:
• Cut and shred grass and deposit it on
the ground ("mulching" effect).
• Cut grass and discharge it on
the ground from the read.
EN - 3