Varian Turbo-V 1000 ICE Manual De Instrucciones página 67

•
Press the PUMP CURRENT push-button and the
display shows (e.g.):
When there is only one temperature sensor
X X K R P M
T 1 = X X ° C
When there are two temperature sensors
X X K R P M
T 1 = X X ° C
where:
•
I = is the DC current drawn by the pump
range (0.00 to 10.0 Ampere)
•
P= is the DC power drawn by the pump
(range 0 to 999 Watt)
•
KRPM = is the theoretical rotational speed of
the pump as a function of the controller output
frequency (range 3 to 38 KRPM)
•
T1 = is the temperature of the outer ring of the
upper bearing (range 00 to 99°C)
•
T2 = is the temperature of the outer ring of the
lower bearing (range 00 to 99°C)
•
Press the PUMP CURRENT push-button and the
display shows
X X K R P M
T 1 = X X ° C
•
Press the PUMP CURRENT push-button and the
display shows
X X K R P M
N 2 = X X X
where:
•
N2 = Gas flow (Nitrogen or Argon) expressed in
SCCM (Standard cubic centimeters per minute)
P = X X X W
I = X X . X A
P = X X X W
T 2 = X X ° C
P = X X X W
I = X X . X A
P = X X X W
S C C M
•
Press the PUMP CURRENT push-button and the
display shows
L A S T A L A R M :
T = X X X X X h
where:
•
Last alarm
•
T
•
C
•
Press the CYCLE NUMBER push-button twice and the
display shows:
X X X X C Y C L E
P U M P L I
where:
•
CYCLE = are the cycles performed (range 0 to
9999)
•
m = is the elapsed time related to the cycle
number displayed (range 0 to 99999 minutes)
•
PUMP LIFE = is the total operation time of the
pump (range 0 to 99999 hours).
•
Press the CYCLE NUMBER push-button and the
following is displayed:
H I G H P O W E R
where:
•
X = is the total number of high power start
sequences performed by the controller.
61
TECHNICAL INFORMATION
X X X X X
C = X X X X X
= number of alarms
sounded
= Pump life span relating
to the last alarm
= Cycle during which the
last alarm occured
X X X X X m
F E X X X X X h
S T A R T
X
87-900-951-01 (B)