Wega Polaris Manual De Uso página 64

Polaris
Cleaning
CAPPUCCINO MAKER
Clean several times a day as indicated in
Paragraph "Cappuccino", especially if used
continuously.
FILTERS and FILTER HOLDERS
Clean the filter holders daily by leaving them
immersed in hot water all night so as to allow
greasy coffee deposits to dissolve; afterwards,
rinse off everything with cold water.
Perform the same cleaning weekly for 10 minutes
in hot water and the appropriate cleaner.
Failure to clean the filter holders daily will
jeopardize the quality of the coffee and the
proper functioning of the filter holder.
Warning: only immerse the cup of the
filter holder. Avoid immersing the handle
in water.
STEAM NOZZLE - MILK FOAMER -
AUTOSTEAMER
Keep the nozzle clean at all times using a cloth
dampened in lukewarm water.
PERFORATED DISK
and CONTAINMENT
RING
Loosen the screw (A)
and remove the
perforated disk (B) and
containment ring (C) from the delivery group.
Wash with hot water.
BODY
Clean the panels of the body with a cloth
dampened in lukewarm water. Do not use
abrasive detergents which may scratch the
surface of the body.
Remove the tray and the cup holder grille and
wash with hot water. During the cleaning
operations, pay attention to the edges and
protruding parts
64
XXX
X
X
C
B
X
A
X
Cleaning
CUP TRAYS
Disconnect the trays from their housing by
positioning them horizontally and pulling them
outwards.
Clean with a cloth dampened in lukewarm
water.
Reinsert the trays in their housing.
STEAM NOZZLE - MILK FOAMER -
AUTOSTEAMER
Check and clean the terminals of the steam
nozzles, using a small needle to reopen the exit
holes.
Clean the inside of the nozzle at least once a
week:
dip the nozzle into a jug of water mixed
with a specific cleaner according to the
manufacturer's instructions;
heat the solution with the steam of the nozzle;
keep the nozzle immersed in the solution for at
least 5 minutes so as to allow the cleaner to rise
up into the nozzle as a result the cooling effect;
repeat the operation 2 or 3 times so that
subsequent dispensing don't leave milk
residue.
DISPENSING UNIT
Carry out the washing of the groups as
indicated in Chapter "Group washing" and
follow the instructions below:
use the blind filter holder;
pour the detergent on the solid filter and
attach the filter holder;
Carry out a series of dispensing until the water
comes out clean;
remove the filter holder from the unit and
carry out at least one delivery so as to
eliminate any detergent residues.
GRINDER-DOSER
Clean the inside and outside of the receptacle
and doser of the grinder-doser with a cloth
dampened in lukewarm water.
X
X
X
X
User manual