iwc 3707/9277 Instrucciones De Manejo página 16

Rejoining the bracelet
Place the links from the two sepa-
rate halves of the bracelet together
again and push the hinge pin oppo-
site the marking into the bracelet
from the side until it protrudes by
approximately 3 mm (1).
Push down the securing pin with
the enclosed tool and at the same
time push the hinge pin in until it is
flush with the side of the bracelet
(2 and 3). When released, the se-
curing pin should be flush with the
upper edge of the securing link. If not, check that the
hinge pin is seated correctly.
Status July 1997.
All specifications subject to change.
28 | 29