Storage And Transport - EMAK CR 270 Serie Manual De Uso Y Manitenimiento

not drive sitting or standing inside the
box itself.
I
- Do not stand under the box when it is in
the up position.
- Always fasten the box with the locking
mechanism; it may rise while the machine
GB
is in motion, causing the load to tip over
or fall.
F
The sides of the box can be opened to
facilitate the loading and unloading:
D
1. To slide the sideboards towards the inside or
the outside, first loosen the screws (A, Fig.15)
which are positioned in 6 points: two under
the front sideboard and two on each lateral
E
sideboard, one on the bottom and one on
the side.
2. Pull the sideboard to the desired position
NL
(Fig. 16).
3. Fasten the screws (A).
P WARNING - Be sure to firmly attach
the screws (A) after opening or closing
the sideboards. If they open while the
machine is in motion, they could be
H
damaged and cause injury to you and
others.
SK
To raise the box
1. D i s e n g a g e t h e l o c k i n g m e c h a n i s m
(C, Fig.17), pulling upwards.
2. Pull the handle (B) upward and lift the box.
CZ
To lower the box
RUS
UK
1. Hold the handle (B, Figure 17) and lower the
box until it rests against the rubber pads.
2. Reinsert the locking mechanism (C) by
PL
pushing down.

6.4 Storage and Transport

FIN
Storage
For engine storage operations, follow the
BIH
instructions given in the manual of the
SRB
engine.
HR
WARNING!
- Allow to cool hot parts such as the engine
and the gearbox, before storing the
machine in any indoor environment. Be
30
careful not to touch them. B efore
covering with a plastic sheet, make sure
they are cold enough.
- Place the machine in a covered place, on a
flat, stable surface, with the tank empty
and out of the reach of children.
- E m p t y t h e f u e l a n d o i l t a n k s a n d
reassemble the respective caps (4 and 7,
Fi g. 2 ) . D i s p o s e o f f u e l a n d o i l i n
accordance with the rules and respecting
t h e e n v i r o n m e n t . U s e a p p r o v e d
containers and avoid spills.
- To reduce the fire hazard, keep the engine
and especially the muffler and the tanks
free of grass, leaves or excessive grease.
CAUTION
- Clean the machine thoroughly washing it
with water and dry it. Never use water jets
or solvents to remove dirt. Be careful not
to get water in the air filter and electrical
components; they may be damaged.
- Always lower the transport box.
- Clean up the air filter.
- Check the wear of the engine starter rope.
Prolonged inactivity
If you plan an extended inactivity period (more
than 1 month), follow the instructions in the
engine manual and the start up procedures in
this manual (page 28), which are the same that
are made during the machine normal start up.
WARNING - When you resume work,
make sure there are no fuel leaks from
the tubes, valve and carburetor.
Transporting
WARNING: The machine must not be
driven on a public road.
- To transport the machine, use a suitable
motor vehicle of adequate power and size or
an approved trailer.
- When loading the machine onto the vehicle,
always choose a level area that is away from
traffic and free from potentially hazardous
objects.
- The machine is heavy and may cause serious