Troubleshooting; Quickly Solve Any Problems You May Encounter While Using The Machine) - EMAK CR 270 Serie Manual De Uso Y Manitenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 73
I
WARNING: always stop the machine before carrying out any of the corrective checks
recommended in the table below, except when they require the unit to be in operation.
When all the possible causes have been checked and the problem is not resolved, consult an
Authorised Service Centre. If a problem occurs that is not listed in this table, consult an Authorised
GB
Service Centre.
PROBLEM
F
1. Engine does not start.
D
E
2. Starting is difficult or
the engine runs
erratically.
NL
3. Erratic forward
movement, poor drive
P
when going uphill or
machine has a
tendency to rear up.
H
4. The drive does not
work
5. The machine does not
SK
bend to the left and /
or right
6. In the parking position,
with the engine
CZ
running, the machine
tends to move forward
7. In the parking position,
RUS
UK
on slopes and with the
engine off, the
machine moves
PL
8. Machine noisy at the
start
9. The crawlers touch the
box when the machine
FIN
is running
10. The gears do not
BIH
engage
SRB
HR
11. Noisy machine when
running
WARNING: Do not attempt to carry out repairs without the necessary repairs and
technical expertise. Poorly executed repairs will automatically invalidate the warranty
and relieve the manufacturer of all liability.
36

13. TROUBLESHOOTING

POSSIBLE CAUSES
a) no fuel supply
b) faulty ignition
c) carburetor throttle does not
close completely
Carburetion fault
a) problems with the
transmission belt tension
b) transmission problems
c) incorrect belt tension
d) worn or broken belt
The cable release lever drive
shafts is not properly adjusted
Incorrect belt tension
Brake shoes worn or
incorrectly adjusted
Incorrect clutch lever cable
tension
Incorrect crawlers tension
Gear shoe worn
The drive does not work
properly
SOLUTION
a) - check fuel level
- open fuel stop-cock
b) - check that spark plug cap is
firmly fitted
- check that the electrodes are
clean and correctly spaced
c)
contact an Authorized Service
Center
- clean or replace air filter
- empty fuel tank and refill with
new fuel
- check fuel filter and replace if
necessary
Contact an Authorised Service
Centre
Contact an Authorized Service
Center
Contact an Authorized Service
Center
Contact an Authorized Service
Center
Contact an Authorized Service
Center
Contact an Authorized Service
Center
Contact an Authorized Service
Center
Contact an Authorized Service
Center
Contact an Authorized Service
Center

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido