Preparing The Machine; Moving The Packaged Machine; How To Unpack The Machine - TSM GRANDE BRIO RIDE ON 75 Manual Del Usuario

6

PREPARING THE MACHINE

6.1

Moving the packaged machine

The machine is contained in specific packing (box + two-way pallet to be lift up only on the longer side) with a platform so
that it can be moved by a fork-lift.
Total weight is 160 kg (without batteries).
Packing dimensions are:
Lenght: mm 1200
Width: mm 800
Height: mm 1520
The fork lift or the transpallet have to pick up the pallet at the center, the item has to be
moved very carefully without crash and paying attention to lift it up over the reasonable height.
Packing crates cannot be stacked
6.2

How to unpack the machine

1. Remove the outer packing lifting with a screwdriver the clips that join box and pallet. The machine is fastened to its
platform by wedges that clamp its wheels and with a polyethylene blade;
2. Remove the blade with suitable nippers paying attention to its elastic return;
3. Use the ramp that you will find in tha packaging to lower the machine off the platform, pushing it in
reverse;
4. Keep the platform since it may be necessary to transport the machine again.
6.3 Putting the batteries in the machine
The batteries must be housed in the battery compartment below the solution tank and must be handled using special
hoisting equipment suitable both for the weight and for the hooking system.
Strictly comply with the instructions given by the battery manufacturer or retailer regarding battery
maintenance and daily recharging. All installation and maintenance procedures must be carried out by
specialists. All the recharging operations must be carried in well-aired places, far from heat
sources.
When you manipolate batteries always wear safety cloth according to the currently laws.
In particular, before manipulating batteries, take off all metallic objects such as rings,
necklace and watches from hands, wrists and neck. Do not lean metallic objects on the
batteries.
When inserting the batteries:
1. Check that the tanks are empty;
2. Unscrew the handwheel that fix the cleaning tank to the chassis;
3. Turn the tanks till the complete reversement;
4. Install the battery following the schema and connect them with wirings given;
5. Cheking not to damage cables, reposition the tanks at the original position;
6. Screw the handwheels that fix the cleaning tank to the chassis.
6.4 Connecting the battery connector
The battery connector is located below the driving seat and must remain connected to the machine
either while running than during re-charge.
6.5 Recharge of batteries
In order not to cause the risk of permanent damage to the batteries, one should at all costs avoid their complete
discharge and effect recharging within a few minutes after that the signal lamp of discharged batteries begins to blink.
Never leave the batteries completely discharged, even if the machine is not being used. Do not leave
one battery to discharge separately from the other. Every 10 recharging operations check the level of the
electrolyte and, if necessary, top up with distilled water. Fill up each batterie cell only after
charging. After the filling up replace and screw the batteries caps
When recharging the batteries, keep the seat lifted and blocked. Make sure that the battery charger fits the
installed batteries both for capacity as for type. Use ONLY TRACTION batteries OPEN/PURE LEAD/ACID or
GEL. Never charge a GEL battery with an unsuitable battery charger. Carefully follow the instructions
given by the manufacturer of batteries and battery charger.
Technological Systems by Moro S.r.l. (T.S.M. S.r.l.)
Via F.lli Zambon,9 - 33080 Z.I. Praturlone - Fiume Veneto (PN) – ITALY
Tel.: +39 0434 564167; Fax: +39 0434 954069
Mail: info@tsmitaly.com
GRANDE BRIO RIDE ON 75
OPERATING MANUAL
- Website : www.tsmitaly.com
17
V01