Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GRANDE BRIO RIDE ON 75
OPERATING MANUAL
* It is the license plate indication by the bulb manufacturer. The duration is variable and depends on the frequency of ON/OFF operations as well.
4 PREPARING THE MACHINE
Moving the packaged machine
4.1
The machine is contained in specific packing (box + pallet) with a platform so that it can be moved by a fork-lift. The packaging
dimensions are:
A. 1200 mm
B. 800 mm
C. 1590 mm
WARNING
- The fork lift or the transpallet have to pick up the pallet at the center, the item has to be moved very
carefully without crash and paying attention to lift it up over the reasonable height.
How to unpack the machine
4.2
1. Remove the blade with suitable nippers paying attention to its elastic return;
2. Remove the outer packing lifting. The machine is fastened to its platform by wedges that clamp its wheels and with a polyethylene
blade;
3. Lift up scrubber group and squeegee;
4. Use the ramp that you will find in tha packaging to lower the machine off the platform, pushing it in reverse;
5. Keep the platform since it may be necessary to transport the machine again.
Inserting the batteries in the machine
4.3
The batteries must be housed in the battery compartment below the solution tank and must be handled using special hoisting
equipment suitable both for the weight and for the hooking system.
WARNING
– For the maintenance and daily recharging of the batteries, it is necessary to follow the instructions
provided by the manufacturer or its dealer. All installation and maintenance operations must be carried out by
specialized personnel. Do not smoke, do not approach naked flames, do not use emery wheels and welding
machines; however, do not cause sparks near the batteries. Do not draw power from the battery with temporary
clamps, sockets and contacts. Make sure that all connections (cable lugs, sockets, plugs, etc.) are always well
tightened and in good condition. Check the integrity of the battery modules.
When handling batteries, always wear the safety clothing required by specific regulations. In particular,
before carrying out any work on the batteries, remove any metallic item from hands, wrists and neck, eg.
rings, watch chains. Do not place tools or metal objects on top of the batteries.
When inserting the batteries:
1. Check that the tanks are empty;
2. Unscrew the handwheel that fix the cleaning tank to the chassis;
3. Turn the tanks till the complete reversement;
4. Install the battery following the schema and connect them with wirings given (Fig. 14);
5. Cheking not to damage cables, reposition the tanks at the original position;
6. Screw the handwheels that fix the cleaning tank to the chassis.
Connecting the battery connector
4.4
The electrical connection of battery / machine is located under the seat, on the left side (the battery connector is mobile and it has
a handle, while the connector machine goes up to the frame).
During operation, the battery connector must remain connected to the machine; during re-charge, the battery connector must be
attached to the charger (Nr. 15 ofMACHINE COMPONENTS table).
Recharge of the batteries
4.5
In order not to cause the risk of permanent damage to the batteries, one should at all costs avoid their complete discharge
and effect recharging within a few minutes after that the signal of discharged batteries appears.
WARNING
– To avoid permanent damage to the batteries, it is essential to avoid their complete discharge, and to
recharge them within a few minutes after the warning of low batteries. Recharge IMMEDIATELY after discharge: DO NOT
LEAVE THE BATTERIES, EVEN PARTIALLY, DISCHARGED.
For the maintenance and daily recharging of the batteries it is necessary to follow the instructions provided by the
manufacturer or its dealer. All installation and maintenance operations must be carried out by specialized personnel.
The battery recharging operations are to be carried out in well-ventilated places and far from heat sources. Do not smoke,
22
Publicidad
Tabla de contenido
