Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
9
AFTER WORK IS TERMINATED
a) Disk brush version
At the end of the work, before performing any type of maintenance proceed as follows;
1. Close the cock;
2. Turn off brush motor switch;
3. Lift the levier of the brush group;
4. Turn off aspiration motor switch;
5. Lift up the lever of the squeegee;
6. Move the machine to the dirty water drain site;
7. Turn the On-Off key to "0", a quarter of a turn counter-clockwise to turn the machine off;
8. Detach the tube from its seat, unscrew the drain plug and drain the recovery tank;
Always wear gloves when doing this to protect yourself from contact with hazardous solutions. Make
sure there are no people or objects nearby.
10 DAILY MAINTENANCE
These operations can be done with the machine switched off, with the On-Off key operated switch in
the "0" position. Always wear gloves when doing this to protect yourself from contact with hazardous
solutions.
10.1 Cleaning the recovery tank
1. Empty the tank through the drain hose;
2. Open the black lock placed between the the recovery and cleaning tanks;
3. Take away the suction hose tank-motor (Fig. 6-1) and the suction hose tank-squeegee (Fig. 6-2);
4. Unlock the plastic cover placed on the top of the machine (Fig. 6);
5. Turn the back part of the cover and take away the complete cover (Fig. 6);
6. Unscrew the anti-foam filter that is fixed on the cover, take it away, and rinse it
7. Turn the recovery tank, rinse it and clean the drain plug
8. Put the plug back on the drain hose and lift it up to the support
9. Repeat by performing these procedures in reverse order in order to start again to work
For the discharge of the liquids used for the floor cleaning, follow the indication written on the
soap label and applicate the currently laws and codes.
10.2 Cleaning the floor-wiper
1.
Remove the suction hose from the floor-wiper;
2.
Unscrew the fixing hadwheels, and pull out the floor-wiper;
3.
Clean the rubber blades and the floor-wiper with a jet of clean water (Fig. 7-1)
4.
Check the condition of the rubbers and reverse or replace them as necessary.
5.
Clean the wiper tube and make sure it is not clogged.
10.3 Removing the brushes
a) Disk
1. Lift up the brush group;
2. With the brush group in its raised position, press down for each brush (Fig.1).
Technological Systems by Moro S.r.l. (T.S.M. S.r.l.)
Via F.lli Zambon,9 - 33080 Z.I. Praturlone - Fiume Veneto (PN) – ITALY
Tel.: +39 0434 564167; Fax: +39 0434 954069
Mail:
info@tsmitaly.com
GRANDE BRIO RIDE ON 75
OPERATING MANUAL
- Website :
www.tsmitaly.com
21
V01
Publicidad
Tabla de contenido
