Measuring The Carrier / Noise Ratio (C/N) - Promax PROLINK-4/4C Premium Manual De Instrucciones

In addition to the video carrier / audio carrier level ratio (15.0 dB in previous
figure) this also shows the frequency or channel, depending on the tuning mode
selected, and the level of the video carrier and audio carrier.

4.9.1.3 Measuring the Carrier / Noise Ratio (C/N)

The PROLINK-4/4C
Auto:
Reference noise:
To select the measuring method activate the TV mode functions menu by
pressing the rotary selector [4], then turn it to select C/N setup function and finally press
it again. The monitor will show a screen displaying two possibilities: C/N (Auto) and C/N
(Reference noise), then turn the rotary selector to select the desired option and finally
press it to confirm.
When selecting the C/N (Reference noise) mode it is necessary to define the
noise frequency: access the functions menu and now turn the rotary selector to select
Reference noise function and finally press it again. A screen titled REFERENCE
NOISE will be displayed showing the noise frequency in use. To change it press key
[31], the current frequency value will disappear and, using the keyboard, you will
be able to enter the new reference noise frequency in MHz and with two decimals
figures. This frequency also can be modified in the Spectrum operation mode (see
4.10.2.2. C/N (Referenced) Measurement).
The PROLINK-4/4C
ways, according to the carrier type and the band in use:
A) Terrestrial band, analogue carrier
Carrier level is measured using a quasi-peak detector (230 kHz BW). Noise level
is measured with an average detector and corrected to refer it to channel
equivalent noise bandwidth (according to the definition of the selected standard).
B) Terrestrial band, digital carrier
Both measurements are done with an average detector (230 kHz) and the same
corrections are introduced on them (bandwidth corrections).
C) Satellite band, analogue carrier
Carrier level is measured using a quasi-peak detector (4 MHz BW). Noise level is
measured with an average detector (4 MHz) and corrected to refer it to channel
bandwidth.
D) Satellite band, digital carrier
Equivalent to case B but now using the 4 MHz BW filter.
Page 36
Premium offers two ways to make this measurement:
The PROLINK-4/4C
noise level is measured automatically.
The user defines the frequency where noise level is
measured (by means of the Reference noise function).
This frequency will be used to measure noise level for all
channels.
Premium carries out C/N ratio measurement in four different
USER'S MANUAL. PROLINK-4/4C
Premium defines the frequency where
Premium
06/2005