Promax PROLINK-4/4C Premium Manual De Instrucciones página 210

To define the configuration of the Datalogger function press key
repeatedly until you have selected the Config field and then press the rotary selector
[4]. The configuration screen of the Datalogger function will then appear.
Figure 46.- Configuration of the DATALOGGER function
After an interval of half a minute without the PROLINK-4/4C
being touched, it will automatically return to the Datalogger function main screen.
1.- TO MEASURE, PRINT OR MEASURE AND PRINT?
First of all, the user must indicate whether he wants to take measurements or to
print them, or to do both at the same time. To do this, press the
repeatedly until positioned in the Measure field. Then turn the rotary selector [4] to
activate (On) or deactivate (Off) the measurement function and press
The next step is to activate or deactivate the measurement printing function. To do this,
use the key [31] to position the cursor in the Print field and activate it (On) or
deactivate it (Off) turning the rotary selector [4] and pressing it validate the new state.
2.- MULTIPLE MEASUREMENTS: INTERVAL BETWEEN MEASUREMENTS
In the case of having to take multiple measurements at different times the
Measure interval will have to be defined. This field specifies the time interval between
measurements/print-outs. To define it, from the Datalogger configuration screen,
repeatedly press key
interval field has been activated, define the hours by turning the rotary selector [4], then
press key [31] again to go to the minutes field and define these in the same way.
Finally press key
Page 74
[31] until the section dealing with time in the Measure
[31] again to validate the defined time interval.
USER'S MANUAL. PROLINK-4/4C Premium
[31]
Premium controls
[31] key
[31] key.
06/2005