ROTOR INpower ROAD Manual De Usuario página 43

2. . UNINSTALL YOUR OLD CRANKS 2
2. .a. If you already have a ROTOR crankset 2
1*. Remove drive-side bolt using an 8 mm allen wrench.
2*. Remove drive-side nut using a cassette lockring tool (Shimano
TL-FW30 or similar).
3*. Screw the drive-side bolt clockwise into the spindle.
4*. Flip the drive-side nut over and screw it clockwise into the crank
arm to be used as a selfextracting cap. It must be flush with the
outer face of the arm and all of its threads must be engaged.
5*. Unscrew the drive-side alloy bolt counterclockwise using an
8 mm allen wrench until the drive-side
assembly disengages from the spindle.
2. .b. If you have a crankset from 2
another manufacturer
Read the corresponding instructions to correctly
remove cranks from another manufacturer.
WARNING!
Do not follow steps 1*
to remove INpower cranks. In this case ®
go to page 4 6 of the
Cranks installation
TL-FW30
. to 5* . if you want
INpower ® manual.
43