ROTOR INpower ROAD Manual De Usuario página 45

2.4. DRIVE-SIDE CRANK ASSEMBLY INSTALLATION
2. .1. 4 Place a 0.5 mm plastic washer on
the axle next to the chainring.
2. . . 4 2 S elect the appropriate spacer(s)
the drive-side on page 41 or 42 and pass
it through the axle next to the 0.5 mm
washer.
2. . . 4 3 Lightly grease the outside of the
axle to facilitate passage through the
bearings. Insert the drive-side crank
assembly through the
frame.
For MTB cranks installation, make sure
that the bearings are situated more to
the outside than the limit lines marked
on the axle.
2. 5. LEFT -SIDE CRANK ASSEMBLY SPACER SELECTION
2. .1. 5 Grease the left
2. .2. 5 S elect the appropriate spacer(s)
the left-side on page 41 or 42 and place
it between the frame and the left crank.
for
bearings and
end of the axle.
for
0.5 mm plastic washer
Grease
Spacer selected
from page 41 or 42
WARNING!
Do not strike or force the cranks to avoid
damaging the product.
Spacer selected
from page 41or 42
Cranks installation 45