ROTOR INpower ROAD Manual De Usuario página 53

6.2.5. Place the contact set in its housing, with the two tabs in the two corresponding housings. Turn
the contact clockwise to ensure that the battery makes contact.
6.2. . 6. The O-ring in the cover set and its placement in the crank come lubricated, however with use
it is advised to lubricate them again when changing the battery. Use lubricants free of lithium
or other substances that could damage the O-ring material
6.2. . 7 Thread the cover set clockwise using an 8 mm allen wrench to 8-10 Nm to ensure the sealing
of the system. Once in this position the battery cover is properly closed and the replacement
process has finished.
Contact set in opened position
Make sure the contact is not damaged after extracting it. This might produce connectivity
errors.
Verify that the O-ring
Use only batteries in good condition; discard those that show signs of corrosion.
Do not throw the old batteries away with normal waste; batteries should
be disposed of properly according to local regulations.
WARNING!
s are well-positioned
WARNING!
.
Contact set in closed position
and not damaged and replace them if needed.
Battery 53