S-Computer; Keypad - Alliance Laundry Systems HC25SN Operación/Programación

Safety
Theory Of Operation

S-Computer

The S-computer control is a programmable solid-
state control capable of storing and running up to 30
cycles. A detailed description of these cycles can be
found in the Programming section of this manual
under S-computer Standard OPL Cycles.
If this machine's computer has been equipped with
special preprogrammed cycles, a separate insert
listing these cycles has been included in the
resealable plastic bag which contained this manual.
Never turn the power off while the computer
Note:
mode switch is in the PROGRAM position. Such
action will disorder portions of the programmed
data, necessitating reprogramming of some or all of
the existing cycles. Always return the mode switch
to RUN position before turning the power off.

Keypad

Operation of the S-computer control is performed
with a 4-key touch keypad and LED display located
on the front of the machine. See Figure 3. The
following table describes the function of the
individual keys when the machine is in RUN mode.
14
(Continued)
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Keypad
Key Description
Used in cycle selection; pressing this key
Up
moves among cycles from smaller to greater.
Used in cycle selection; pressing this key
Down
moves among cycles from greater to smaller.
Start Used to start a cycle.
Stop Used to stop a cycle.
Up Down
Figure 3
LED Display
Start Stop
B008RE3A
F232073