Display Indications - Alliance Laundry Systems HC25SN Operación/Programación

The following table lists the various displays and
what they mean. The operator should become
familiar with these computer displays.
Display Meaning
Program identification code (ROM)
S-05
This is an example only.
Hold Wait...power has just been turned on.
CY Cycle (followed by two-digit number)
CHEC/CYC* Test cycle selected.
FAr Degrees Fahrenheit
CEL Degrees Celsius
PrE Prewash segment (1st of 8 segments)
UASH Wash segment (2nd of 8 segments)
FIL1 First rinse (3rd of 8 segments)
FIL2 Second rinse (4th of 8 segments)
FIL3 Third rinse (5th of 8 segments)
FIL4 Fourth rinse (6th of 8 segments)
FIL5 Fifth rinse (7th of 8 segments)
FIL6 Sixth rinse (8th of 8 segments)
CFIL Cold fill
Reads "SPIn" for one second, then
SPIn/tIME*
"tIME" followed by time for spin.
Temperature sensor failure or temperature
tSFL
out of range.
*Display indications separated by a slash represent an alternating display.
F232073

Display Indications

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Display Meaning
bFIL Warm fill (both hot and cold)
HFIL Hot fill
LOLE Low water level
HILE High water level
SUP1 Supply 1
SUP2 Supply 2
SUP3 Supply 3
SUP4 Supply 4
SUP5 Supply 5 (supply 1 and 2)
SUP6 Supply 6 (supply 2 and 3)
SUP7 Supply 7 (supply 3 and 4)
STOP Stop routine
SdLY Spin coast delay
donE Cycle and stop routine have ended.
door Door not properly closed.
Programmed water level not reached after 30
FILL/STOP*
minutes.
The computer detects low water level or higher
FULL
when none should be present.
Safety
15