Inglesina Darwin infant i-Size Manual De Instrucciones página 33

Check that the car seat is correctly attached by trying to lift it.
fig. 25 Once the Darwin Infant i-Size car seat is attached to the Darwin i-Size
base, press the two buttons (B) simultaneously and rotate the handle of the car seat
forwards as far as it turns. Make sure that the two buttons (B) come out completely,
after arranging the handle in position.
REMOVING THE DARWIN INFANT i-SIZE CAR SEAT FROM THE DARWIN i-SIZE BASE
fig. 26 Pressing the two buttons (B) simultaneously, rotate the handle of the car
seat to vertical position.
The Darwin Infant i-Size car seat can be removed in two ways.
fig. 27 Option 1. - Operating the rear lever (H), simultaneously lift the Darwin
Infant i-Size car seat from the Darwin i-Size base, gripping it with the handle.
fig. 28 Option 2. - Pressing the release lever (P) on the base, simultaneously lift the
Darwin Infant i-Size car seat from the Darwin i-Size base, gripping it with the handle.
USE WITH INGLESINA EASY CLIP CHASSIS
For the correct use of the Inglesina Easy Clip chassis, refer to the dedicated manuals.
fig. 29 Properly open the chassis, following the suitable instructions. Holding the
Darwin Infant i-Size child car seat by the handle, place it on the chassis on the central
pin making sure that the brakes are always properly engaged and that there is not any
carrycot or seat unit installed. Then, push the child car seat downwards until hearing
both CLICK sounds indicating the occurred hooking.
CAUTION: always make sure that the child car seat is properly hooked before use.
fig. 30 To remove the child car seat, act on the rear lever (H) and simultaneously lift
it holding it by the handle.
33