Modbus Tcp; Application Software - Mettler Toledo IND560 Guia De Instalacion

IND560 Installation Manual
to 500Kbits per second depending on cabling and distances. Messages are limited
to 8 unfragmented bytes. The network can include up to 64 nodes including the
master, commonly called the scanner.
PROFIBUS DP
The IND560 Terminal communicates to a PROFIBUS-DP master according to
DIN 19 245. The PROFIBUS option consists of a module and software that resides
in the IND560 Terminal, which implements the data exchange.
EtherNet/IP
The IND560 supports communications of the EtherNet/IP interface option and the
appropriate driver software.

Modbus TCP

Modbus/TCP is used to establish master-slave/client-server communication
between intelligent devices. It is an open standard network protocol, widely used in
the industrial manufacturing environment. The ModbusTCP protocol takes the
Modbus instruction set and wraps TCP/IP around it. The Modbus TCP protocol is
supported by the EtherNet/IP interface board, version 1.32 or higher.

Application Software

Installing Application Software
When a hardware key (also referred to as an iButton) enabling IND560 application
software is installed or removed, a pop-up message will appear instructing the
user to perform a master reset. The master reset can be performed with or without
resetting metrologically significant EEPROM (Scale) data, depending on the
positions of switches SW2-1 and SW2-2. Both of these switches must be set to
ON in order to reset EEPROM data to its factory default values. If either of them is
set to OFF, EEPROM data is preserved. Refer to Chapter 4 of this manual, Service
and Maintenance, for details on performing a master reset.
Fill-560
The Fill-560 is a special application that can be added to the IND560 terminal to
provide additional filling and dosing control. It provides control for the following
combinations of weigh-in and weigh-out sequences.
Fill only
•
Fill and dump
•
Dose out only
•
Additional information can be found in the Fill-560 & FillPlus Manual, part #
64057366, found on the documentation CD that accompanies these application
software kits or a terminal that has been factory configured with the Fill-560 or FillPlus
software.
1-14
Fill and dose out
•
Blend only
•
Blend and dump
•
Blend and dose out
•