External Sealing Of The Harsh Enclosure - Mettler Toledo IND560 Guia De Instalacion

IND560 Installation Manual
3. Thread the wire cable and plastic seal (Figure 2-58) included with the kit
through the holes in the new screws. The U.S. requires use of only two of the
screws (Figure 2-59), Canada requires use of all three (Figure 2-60).
4. Thread the end of the wire cable through the plastic seal and snap the seal
shut.

External Sealing of the Harsh Enclosure

For external sealing of the harsh enclosure, refer to Figure 2-58 and Figure 2-61
and follow these steps:
1. Ensure that the appropriate approval region has been selected in setup under
Scale > Type > Approval and that the Metrology security switch SW1-1 is in
the "on" position.
Refer to Closing the Harsh Enclosure on page 2-4 for the correct method to use
when replacing the front panel.
2-36
Figure 2-58: External Sealing Wire
Figure 2-59: External Sealing for United States
Figure 2-60: External Sealing for Canada