Attach Seal - Eaton xChargeIn Serie Manual De Instalación

Commissioning
3) Hook in the housing cover at the top
4) Secure the housing cover with two screws at the bottom.
All covers are mounted and the charging station is ready for use.
9.4

Attach seal

Depending on the scope of delivery, devices are available for sealing the ter-
minal cover and the connection panel cover. If required, these can be used
to prevent or identify tampering attempts by unauthorized persons at charg-
ing stations with preconfiguration or special suitability (MID calibration valid-
ity).
To attach the seals, proceed as follows:
1) If necessary, open the covers of the charging station until the cover to be
2) Loosen the right upper screw of the cover to be sealed.
302
housing cover must glide into the guides without considerable resis-
tance. The housing cover must be correctly seated in the housing guide
on all sides.
sealed is accessible.
1 and close it at the bottom 2. The
Installation manual V1.05
xChargeIn
© EATON