Change Charging Cable (Optional) - EVBOX Elvi Manual Del Usuario

Change charging cable
(optional)
Tools you need to change the cable
Warning: Risk of electric shock.
Before changing the charging cable, make sure that
the power line you're using is switched off on your
service panel. The LED ring of the charging plug
must be off.
1
Take out the keys from the folder in the box.
Insert the keys into the slots in the bottom of the wall
dock. This releases the snap-fit connection of the
charging station to the wall dock. Make sure to push
them in until they only stick out approx. 2" (50 mm)
and cannot be pushed in any further.
Now you can remove your charging station from the
wall dock. Pull the charging station away from the wall
dock in a straight line.
Caution: Do not twist or skew the charging station,
as that might damage the station's snap fits and/or
connectors.
Be aware that the charging station is still fixed on the
connector (socket) of the wall dock and it requires
some force to pull it off.
Caution: Do not use the charging cable for pulling
the station out of the wall dock.
Take out the keys from Elvi wall dock.
2
Turn the charging station around and place the front
face of the station on a soft and stable surface.
Untighten the bolt in the back with the supplied Torx
T30 bit and take the bolt out.
3
Place the station on its side and unplug the old cable
out of the charging station. It is best to store the old
cable in its original packaging.
Bit T30
EN
CLICK
10