Practical Guide For The Operator; Preparing The Machine For Work - Tennant CS5 1251584 Manual De Instrucciones

PRACTICAL GUIDE FOR THE OPERATOR

in a spacious and obstacle-free area to acquire the necessary familiarity with the functions
Always dilute the detergent according to the manufacturer's instructions. Do not use sodium
hypochlorite (bleach) or other oxidants, particularly in strong concentrations. Do not use
solvents or hydrocarbons. The water and detergent temperature must not exceed the
The machine has been designed for use with low-foam biodegradable detergents made
Use only commercially approved cleaning detergents. Machine damage caused by improper
use of the cleaner will void the manufacturer's warranty.
Follow the safety precautions concerning the use of detergents given in the section
Before starting work, put on overalls, non-slip shoes, gloves and all other personal protection
devices recommended by the supplier of the detergent used or appropriate for the type of

Preparing the machine for work

Proceed as follows before starting work.
• Check the battery charge indicator lights to ensure that the battery is fully charged and, if not,
run the recharge cycle, referring to the section "Battery: preparation / installation / recharging".
• Make certain that the dirty water tank is empty, and if not, empty it, referring to the section
"Emptying the dirty water tank".
•
section "Filling the water/detergent tank".
• Adjust the position of the handle, referring to the section "Adjusting the handle rake angle".
• Fit the brush, referring to the section "Fitting the brush/pad driver".
! INFORMATION
and controls.
! WARNING
with the machine stationary.
! WARNING
impurities in the solution.
! INFORMATION
! WARNING
! INFORMATION
! DANGER
work environment.
EN 15