Extra Maintenance - GASPARDO FBR Plus Empleo Y Mantenimiento

ENGLISH

4.2 EXTRA MAINTENANCE

REPLACEMENT OF SECTION-HOLDING BAR (K, Fig. 41)
- With the implement resting on the ground, open the mowing
bar.
- Remove the expansion pin (H, Fig. 39) and pull out the section-
holding bar (Fig. 40) with the hooking tie rod (I, Fig. 40).
- Insert the new section-holding bar and lock it in place with the
expansion pin. Lubricate the cutters with very viscous oil during
the assembly phase. Grese.
REPLACEMENT OF SECTIONS (L, Fig. 43)
- With the implement resting on the ground, open the mowing
bar.
- Remove the expansion pin (H, Fig. 39) and slide out the section-
holding bar (Fig. 40).
- Remove the damaged section using a pin punch.
- Rivet a new section with the rivets provided (L, Fig. 41).
- Insert the section-holding bar and lock it in place with the
expansion pin.
REPLACEMENT OF BAR HOLDING REMOVABLE TOOTH
- With the implement resting on the ground, raise the mowing
bar and secure it with the hooking tie rod.
- Unscrew all the tooth fastening screws (Fig. 42).
- Remove all the teeth (Fig. 43).
- Remove the expansion pin and slide out the bar.
- Insert the new tooth-holding bar and lock it in place with the
expansion pin.
- Reposition the teeth and fasten them with the screws.
REPLACEMENT OF REMOVABLE TOOTH
- With the implement resting on the ground, raise the mowing
bar and secure it with the hooking tie rod.
- Unscrew the screws of the tooth to be replaced (Fig. 42).
- Slide out the tooth (Fig. 43), put in the new one and lock it in
place with the screws. For this it would be advisable to use a
torque wrench, respecting the values of 30 Nm.
40
USE AND MAINTENANCE
H
Fig. 39
g
I
Fig. 40
L
K
Fig. 41
Fig. 42
Fig. 43
cod. G19503010