Salinity Test; Ph/Orp Integrated Controller; Setting The Ph Level - Teuco X762 Manual Del Usuario

EN

SALINITY TEST

The plant is equipped with an integrated system to measure the pool water salinity level.
Press the key "SALT TEST" to carry out the above test.
During the test, the production indicator swings within the range 20%-
80% of the salinity scale, by alternatively indicating the text "SALT" and "TEST"
on the system display. Once test is finished, the indicator flashes for some seconds in the
scale, in correspondence of the detected salinity value. After a few, the system returns to
the normal operating mode.
The system may show salt levels lower than the actual ones in case of temperature
below 20°C.
The pH/ORP integrated controller has a factory calibration with the following setting
parameters.
Set value
To adjust pH properly, make sure water alkalinity is within the recommended range of
60-120 ppm of CaCO3. Check the water total alkalinity level by means of a suitable kit
and, if necessary, adjust it manually.
Keep the key "SET" pressed until the indicator signals the required pH value within the
range 7.0 ÷ 7.8 and release it once once it has been selected.
32
AUTOMATIC WATER TREATMENT KIT