Product Description And Applications; Operating Limits - Nice RUN1800 Instrucciones Y Advertencias Para La Instalación Y El Uso

2) Product description and applications

RUN is a range of irreversible electromechanical gearmotors used for
the automation of sliding gates. They are equipped with an electronic
control unit and an "SM" type connector for radio control receivers
(optional ). Electrical connections to external devices are facilitated
thanks to the use of the "BlueBUS" system, which enables the
connection of several devices by means of just 2 wires. The list of
devices compatible for connection to the Run BlueBUS is given in
chapter 7.3.1 "BlueBUS"; an updated list, with relative compatibility
Other products are also part of the RUN range, the difference of which is described in table 1.
Table 1: comparison of the RUN gearmotor main characteristics
Gearmotor type
Limit switch type
Maximum leaf length
Maximum leaf weight
Peak thrust
(corresponding to a force)
Motor
Note: 1kg = 9,81N for example: 1390N = 142 kg
1

2.1) Operating limits

Chapter 8 "Technical Characteristics" provides the only data needed
to determine whether the products of the RUN line are suitable for
the intended application. The structural characteristics of RUN make
it suitable for use on sliding leaves in conformity with the limits speci-
fied in tables 2, 3 and 4.
The effective suitability of RUN to automate a sliding gate depends
on friction and other factors, even occasional, such as the presence
of ice which could obstruct leaf movement. To ensure suitability, it
is absolutely vital to measure the force necessary to move the leaf
throughout its entire run and ensure that this is less than half of the
"nominal torque" indicated in chapter 8 "Technical characteristics" (a
50% margin on the force is recommended, as unfavourable climatic
conditions may cause an increase in the friction); furthermore, the
Table 2: limits in relation to the length of the leaf
Leaf width(m)
Up to 6
6 ÷ 9
9 ÷ 12
12 ÷ 15
15 ÷ 18
4
RUN1800
electromechanical
Single phase asynchronous maximum 700W
RUN1800/ RUN1800P
max. cycles/hour max. consecutive cycles
42
28
21
17
is also available at: www.niceforyou.com. RUN is equipped with a
connector for remote programming units to enable complete and
quick management of installation, maintenance, troubleshooting of
any malfunctions; refer also to 7.8.1 "Remote programming unit".
RUN is electrically powered, in the event of a power failure, the
device can be released by means of the special key, to enable
manual movement of the gate.
RUN1800P
inductive proximity electromechanical
15m
1800 kg
40Nm
(1110N)
Single phase asynchronous maximum 870W
400mm
data specified in tables 2 and 3 should be taken into account to
establish the number of cycles/hour and consecutive cycles.
max. cycles/hour
28 42
18 28
14 21
11 17
14
RUN2500 RUN2500P
inductive proximity
18m
2500 kg
50Nm
(1390N)
253mm
RUN2500/ RUN2500P
max. consecutive cycles
42
28
21
17
14