Troubleshooting; Drilling Template - MZ electronic NAUTI 030 Instrucciones De Uso

Troubleshooting

FAULT

Drilling template

NAUTI 030
CAUSE
Though UP or DOWN
buttons are pressed, the
instrument doesn't receive
any signal from the
magnetic sensor for more
than 12 seconds.
At start-up buttons UP
and DOWN were
pressed. For normal
operation both buttons are
pressed.
sensore magnetico
magnetic sensor
min.44 mm(1"3/4)
26
English
CORRECTIVE ACTION
Check the sensor electric
connections.
Check if sensor operates
properly. If not, replace it.
Check the position of
sensor and magnet on
gipsy and their distance (3
mm).
Check the operation of
electric installation or
anchor windlass.
Remove the cause of
buttons lockout. In those
conditions outputs are not
enabled.
Rev. 05 – 2007