To Remove The Cutting Deck; To Attach The Cutting Deck - Combi - Husqvarna P 535HX Manual De Usuario

a) For the Combi cutting deck: Pull the spring (A)
and attach the lifting eyes to the cutting deck (B).
B
b) For the R180 cutting deck: Attach the lifting eyes
to the cutting deck (A) with the bolt (B) and the
pin (C).
C
21. Do a check of the parallelism of the cutting deck.
To do a check of the parallelism of the
Refer to
cutting deck on page 53 and To do a check of the
parallelism of the cutting deck on page 55 .

To attach the cutting deck - Combi 155

X
1. Attach the cutting deck. Refer to
cutting deck - Combi 155, R180 on page 26 .
2. Put the hydraulic hoses from the cutting deck
through the loop.
28
A
A
B
To attach the
3. Connect the hydraulic hoses to the coupling on the
product. The flange and the notch must line up
correctly.
Note:
The position of the hydraulic hoses controls
the operation function of the cutting height lever. To
change the operation function of the cutting height
lever, change the position of the hydraulic hoses.

To remove the cutting deck

1. Park the product on level ground.
2. Apply the parking brake.
3. Move the lever for the hydraulic lift arms rearward to
fully lift the cutting deck.
4. Turn the power key to the STOP position.
5. For the Combi 155 X cutting deck, release the
couplings and disconnect the hydraulic hoses.
6. Release the lifting eyes.
a) For the Combi cutting decks: Pull the spring (A)
to release the lifting eyes (B) on the cutting deck.
B
A
1591 - 001 - 21.12.2020