Husqvarna P 535HX Manual De Usuario página 29

b) For the R180 cutting deck: Remove the pin (A)
and the bolt (B) to release the lifting eyes on the
cutting deck (C).
A
7. Start the electrical drive. Refer to
product on page 33 .
8. Put the lever for the hydraulic lift arms to the position
(B) to lower the lift arms.
C
B
A
WARNING:
the hydraulic lift arms to the float position
(A). The force from the lift spring can
cause injury.
9. Turn the power key to the STOP position.
10. Remove the 2 screws and remove the service hatch.
11. Pull back the rubber casing from the shaft joint.
12. Pull back the couplings of the drive shaft and remove
the drive shaft from the PTO shaft on the product.
1591 - 001 - 21.12.2020
C
B
To start the
D
Do not put the lever for
13. Pull back the couplings of the drive shaft and remove
the drive shaft from the bevel gear shaft of the
cutting deck.
14. Remove the locking chains.
15. Remove the pins (A) and the bolts (B) from the lift
arms (C) and joints of the cutting deck (D).
a) For the Combi cutting decks:
B
A
D
b) For the R180 cutting deck:
B
A
To put the Roll Over Protection
Structure (ROPS) in position for the
first time
For the transportation of the product from the factory,
the ROPS is folded above the seat.
B
A
C
B
A
C
29